[cisco-voip] Dial-peer matching question

[Ed Leatherman]

I'm having trouble getting inbound dial-peers to match up. I have the
following scenario

voice-port 0/1/1
 connection plar 39495
 caller-id enable
!
dial-peer voice 1 pots
 description Inbound pots dial-peer for port 0/1/1
 incoming called-number 39495
!
dial-peer voice 300 voip
 description outbound dial-peer to callmanager 10.182.140.10
 destination-pattern 39495
 session target ipv4:10.182.140.10
!

Unfortunately when I watch the debug voice ccapi inout for a call to that
FXO port, it is always matching dial-peer 0.

ug 10 18:08:45.958: //-1/195B3C298092/CCAPI/cc_api_display_ie_subfields:
   cc_api_call_setup_ind_common:
   cisco-username=
   ----- ccCallInfo IE subfields -----
   cisco-ani=
   cisco-anitype=0
   cisco-aniplan=0
   cisco-anipi=0
   cisco-anisi=0
   dest=39495
   cisco-desttype=0
   cisco-destplan=0
   cisco-rdie=FFFFFFFF
   cisco-rdn=
   cisco-rdntype=0
   cisco-rdnplan=0
   cisco-rdnpi=0
   cisco-rdnsi=0
   cisco-redirectreason=0   fwd_final_type =0
   final_redirectNumber =
   hunt_group_timeout =0

Aug 10 18:08:45.958: //-1/195B3C298092/CCAPI/cc_api_call_setup_ind_common:
   Interface=0x46A538BC, Call Info(
   Calling Number=,(Calling Name=)(TON=Unknown, NPI=Unknown, Screening=Not
Screened, Presentation=Al
lowed),
   Called Number=39495(TON=Unknown, NPI=Unknown),
   Calling Translated=FALSE, Subscriber Type Str=RegularLine,
FinalDestinationFlag=TRUE,
*   Incoming Dial-peer=0*, Progress Indication=ORIGINATING SIDE IS NON
ISDN(3), Calling IE Present=FAL
SE,
   Source Trkgrp Route Label=, Target Trkgrp Route Label=, CLID
Transparent=FALSE), Call Id=-1
I've also tried replacing the incoming called-number with "port 0/1/1" to
force it to match on that criteria, but it doesnt match that either. I need
to get the inbound dialpeer nailed down, because when I put the rest of my
dial-peers in, it inevitably chooses another dial-peer in my config and uses
that destination-patters as an incorrect number for the callerID.
>From what I read on cco, the incoming called-number should take precidence
and cause it to match. Maybe this doesnt work because its a PLAR
configuration.. But then when I tried the voice-port, that should have
matched. Its the the port that is ringing in and its the first dial-peer in
the config.

Any ideas what i'm doing wrong here?

-- 
Ed Leatherman
Senior Voice Engineer
West Virginia University
Telecommunications and Network Operations
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060810/1175da3b/attachment.html