[cisco-voip] 0x82AC - Requested circuit/channel not available

Ryan Ratliff rratliff at cisco.com
Fri Aug 11 14:56:57 EDT 2006


Do you have a full E1?  CM is requesting to use channel 31  
exclusively and the other end doesn't seem to think that channel is  
alive.

-Ryan

On Aug 11, 2006, at 2:52 PM, Nesen Kisten ((ZA)) wrote:

Hi All,

I configured my voice gateway with MGCP I can receive calls in fine,  
but when I try callin out

I get 0x82AC - Requested circuit/channel not available

         Sending Complete
         Bearer Capability i = 0x8890
                 Standard = CCITT
                 Transer Capability = Unrestricted Digital
                 Transfer Mode = Circuit
                 Transfer Rate = 64 kbit/s
         Channel ID i = 0xA9839F
                 Exclusive, Channel 31
         Called Party Number i = 0x81, '0027843555674'
                 Plan:ISDN, Type:Unknown
Aug 11 19:46:54.782 GMT: ISDN Se0/2/0:15 Q931: RX <- RELEASE_COMP pd  
= 8  callre
f = 0x8007
         Cause i = 0x82AC - Requested circuit/channel not available


Thanks in Advance

Nesen
This email and all contents are subject to the following disclaimer:

"http://www.dimensiondata.com/emaildisclaimer.htm"

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip



More information about the cisco-voip mailing list