[cisco-voip] Cannot Transfer Call

[Ryan Ratliff]

What version of CM?

Prior to 4.x you would see this when a call was ringing in or another  
call was on hold when you try to initiate a transfer.   It's a limit  
of only having 2 calls active per line.
In 4.x if you see this most likely you need to bump up the max calls  
on the line because it is either set to 1 or they really do have  
another call ringing in and it needs to be increased.

-Ryan

On Aug 16, 2006, at 12:46 PM, Johan Bloemhard wrote:

Anyone have an issue where they try to transfer call and “Cannot  
Transfer Call” displays on the 7941?  We’ve experienced it on a rare  
occasion so I can’t really determine where to start troubleshooting it.



Thanks.



Johan Bloemhard
Senior Information Technology Specialist
___________________________________
Silver Falls School District 4J
802 Schlador Street
Silverton, OR 97381
w: 503.873.6331



Disclaimer: This message may be legally privileged and/or is intended  
only for the use of the addressee(s). The content and views expressed  
in this email may represent the views of the sender and not those of  
Silver Falls School District.

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip