[cisco-voip] deploying qos on my edge router

[ash AD]

James,
   
      You can create policies to mark the traffic on ingress of your interfaces with out queuing it. Then you can analyze the what traffic is being matched based on your policies. Take time to build well documented traffic trend reports. From there you can better determine what needs to be queued. Depending on how loaded down your router is you can also enable IP NBAR protocol discover or use some other deep packet analysis tool to see what is traversing the interfaces. Whatever you do, don't shoot from the hip. Good luck.
   
  Peter

James Grace <jgrace at digitel.net> wrote:
                 
  What would be the best way to apply MQC  on our edge routers  for voice.  If I want to priorities the traffic and allocate the bandwith.  But I have no ideal how much bandwith to allocate for voice.  Most of our voice traffic will be from incoming calls with no answer and them going over the wan to geto unity VM.  Unity is set for g729  and my remote site are set to 729 for site to site and 711 for local 
  Using MQC
   
   
  James D. Grace 
  CCNP CCNA MCSE MCSA 
  Digitel Corporation
  System Engineer / Professional Svc.
  MSN messenger ID:  jgrace29 at hotmail.com
  Mac IChat ID:  jgrace29 at mac.com
   
   

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip


 		
---------------------------------
Get your email and more, right on the  new Yahoo.com 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060830/a887054d/attachment.html