[cisco-voip] 2851 and 12 T1s voice clocking

[Jason Aarons (US)]

Using a NM-HDV seperates the DSPs from the motherboard DSPs. Short story
is the PVDM2s on the motherboard can only clock to single PLL.  Data
doesn't care, but voice is another story.  You would need either
separate ISRs or use multiple NM-HDVs with multiple voice pris with
different clock sources (ld versus local).

 

________________________________

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jonathan
Charles
Sent: Friday, December 01, 2006 9:55 AM
To: Lelio Fulgenzi
Cc: cisco-voip at puck.nether.net; STEVEN CASPER
Subject: Re: [cisco-voip] 2851 and 12 T1s

 

The only time you will get a clocking source problem is if you have
multiple T1s connecting to a router from different destination switches.

For example, you have a frame-relay T1 and a PRI... 

You have to identify to the router which WIC is going to be the master
clock. In which case you will see slips on the other T1. 

I do not believe there is any work-around. It is possible (though
unlikely) that there are some Cisco routers that can have multiple clock
sources...



Jonathan

On 12/1/06, Lelio Fulgenzi <lelio at uoguelph.ca> wrote:

Do the 3800s have this problem? 

 

------------------------------------------------------------------------
--------
Lelio Fulgenzi, B.A.
Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1
(519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ 
"I can eat fifty eggs." "Nobody can eat fifty eggs."

	----- Original Message ----- 

	From: STEVEN CASPER <mailto:SCASPER at mandtbank.com>  

	To: jason.wydra at berbee.com ; cisco-voip at puck.nether.net ;
cmstaffin at ra.rockwell.com 

	Sent: Friday, December 01, 2006 7:18 AM

	Subject: Re: [cisco-voip] 2851 and 12 T1s

	 

	What do you do if you have multiple potential clocking sources?
It is
	likely at a site that you can have connections to Local and Long
	Distance service providers as well as to a PBX. 
	
	Steve
	
	>>> "Craig M Staffin" <cmstaffin at ra.rockwell.com> 11/30/06 2:43
PM >>>
	Biggest problem is going to be that the 2851 can only have one
clocking
	
	source.  So if all 12 terminate to the same CO switch you are
fine 
	otherwise you will have timeing issues.
	
	Craig
	
	
	
	
	"Wydra, Jason" <jason.wydra at berbee.com> 
	Sent by: cisco-voip-bounces at puck.nether.net 
	11/30/2006 01:22 PM
	
	To
	<cisco-voip at puck.nether.net>
	cc
	
	Subject
	[cisco-voip] 2851 and 12 T1s
	
	
	
	
	
	
	Any issue with terminating 12 T1s into a 2851? I have a mixture
of PRI
	and 
	T1 CAS. 6 2MFT-T1 cards. Does this router have the horsepower?
	 
	Jason Wydra
	Berbee
	Cisco Voice Engineer
	8725 West Higgins Road, Suite 700
	Chicago, Il. 60631
	IP phone 773.867.6084
	Cell 630-209-9792
	Jason.Wydra at berbee.com 
	www.berbee.com 
	 
	
	 _______________________________________________
	cisco-voip mailing list
	cisco-voip at puck.nether.net 
	https://puck.nether.net/mailman/listinfo/cisco-voip 
	
	
	_______________________________________________
	cisco-voip mailing list
	cisco-voip at puck.nether.net
	https://puck.nether.net/mailman/listinfo/cisco-voip


_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip



 




-----------------------------------------
Disclaimer:

This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the
designated addressee(s) named above only.  If you are not the
intended addressee, you are hereby notified that you have received
this communication in error and that any use or reproduction of
this email or its contents is strictly prohibited and may be
unlawful.  If you have received this communication in error, please
notify us immediately by replying to this message and deleting it
from your computer. Thank you.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20061201/d3ffd018/attachment.html