[cisco-voip] caller id + DID

[Ted Nugent]

95% of the time the problem is with the provider. You
can send them anything that you want in the the
Display IE or FacilityIE but if they don't have your
DID block "masked" (for lack of a better word)
correctly then no CID. You might try getting with them
and see what they're receiving for starters and if
they will pass it along if you provide it "correctly"
or if they need to lock in your corp name for your
entire block. At any rate if they tell you that they
can pass along if you're configured for X then we can
tell you how to configure for X. My experience is that
your DID block will be masked by your provider with
your corp name and that is the best that they can
provide without some sort of act of congress. Also, I
know this might sounds obvious however I've had
customers that were doing this but you can't test this
by calling your mobile phone since most of them will
never show you the name display.
Ted


--- kevin k <kds850 at gmail.com> wrote:

> i have the following config on 3845 with pri
> dial-peer voice 1 pots
>  description outbound to PSTN Local
>  destination-pattern ..........
>  direct-inward-dial
>  port 0/0/0:23
> 
> and did of lets say 111-222-3000 thru 111-222-3999
> 
> the odd thing is the called id works for incoming
> really well.
> but for the outgoing calls only the "111-222-3000"
> will show up.
> 
> anyway to fix it?
> 
> thanks
> > _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
> 



 
____________________________________________________________________________________
Want to start your own business?
Learn how on Yahoo! Small Business.
http://smallbusiness.yahoo.com/r-index