[cisco-voip] caller id + DID

[kevin k]

here is the debug of q931.
my dn is 1112222412 and the number i call is 3012223333, pstn number.
the numbers have been changed to protect the id.



voip#debug isdn q931
voip#
Dec 18 13:39:25: ISDN Se0/3/1:23 Q931: TX -> SETUP pd = 8  callref = 0x0233
        Bearer Capability i = 0x8090A2
                Standard = CCITT
                Transfer Capability = Speech
                Transfer Mode = Circuit
                Transfer Rate = 64 kbit/s
        Channel ID i = 0xA98381
                Exclusive, Channel 1
        Calling Party Number i = 0x2181, '1112222412'      <--------(((((my
dn, voip phone)
                Plan:ISDN, Type:National
        Called Party Number i = 0xA1, '3012223333'   <-------------((((out
side pstn number)
                Plan:ISDN, Type:National
Dec 18 13:39:25: ISDN Se0/3/1:23 Q931: RX <- CALL_PROC pd = 8  callref =
0x8233
        Channel ID i = 0xA98381
                Exclusive, Channel 1





On 12/13/06, Ted Nugent <tednugent69 at yahoo.com> wrote:
>
> 95% of the time the problem is with the provider. You
> can send them anything that you want in the the
> Display IE or FacilityIE but if they don't have your
> DID block "masked" (for lack of a better word)
> correctly then no CID. You might try getting with them
> and see what they're receiving for starters and if
> they will pass it along if you provide it "correctly"
> or if they need to lock in your corp name for your
> entire block. At any rate if they tell you that they
> can pass along if you're configured for X then we can
> tell you how to configure for X. My experience is that
> your DID block will be masked by your provider with
> your corp name and that is the best that they can
> provide without some sort of act of congress. Also, I
> know this might sounds obvious however I've had
> customers that were doing this but you can't test this
> by calling your mobile phone since most of them will
> never show you the name display.
> Ted
>
>
> --- kevin k <kds850 at gmail.com> wrote:
>
> > i have the following config on 3845 with pri
> > dial-peer voice 1 pots
> >  description outbound to PSTN Local
> >  destination-pattern ..........
> >  direct-inward-dial
> >  port 0/0/0:23
> >
> > and did of lets say 111-222-3000 thru 111-222-3999
> >
> > the odd thing is the called id works for incoming
> > really well.
> > but for the outgoing calls only the "111-222-3000"
> > will show up.
> >
> > anyway to fix it?
> >
> > thanks
> > > _______________________________________________
> > cisco-voip mailing list
> > cisco-voip at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/cisco-voip
> >
>
>
>
>
>
> ____________________________________________________________________________________
> Want to start your own business?
> Learn how on Yahoo! Small Business.
> http://smallbusiness.yahoo.com/r-index
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20061218/4c3a7141/attachment-0001.html