[cisco-voip] Translate Calling Number

[Ruben Montes (EU)]

Hi,

I'm using MGCP protocol and I want to do a translation on the calling
number. 
Number 028281347 calls 85264 (p.e.): I want to strip the 028 to the
calling number, that is a number 'behind' an analog PBX connected with a
QSIG to the gateway.
Which translation pattern should I create?

Regards,

Ruben

-----Mensaje original-----
De: Wes Sisk [mailto:wsisk at cisco.com] 
Enviado el: jueves, 02 de febrero de 2006 3:02
Para: Ruben Montes (EU)
CC: cisco-voip at puck.nether.net
Asunto: Re: [cisco-voip] Applying mgcp changes

No, changes will not be propagated.

Take a look in the CCM traces at the time you see an error similar to:
MGCPBhHandler 10.1.230.10 - ERROR - MGCPNotificationRequest for  
reset: TCP Mgt not supported by the GW.  Sending MGCP err back to  
reload device. GWTCPOpened=1, GWRegistered=1|<CLID::CM3-Cluster><NID:: 
11.1.235.50><CT::1,100,86,1.25><IP::><DEV::>

Basically indicating CM cannot send the change notification to the  
gateway.

'no mgcp' , 'mgcp'
will be required.

/Wes



On Feb 1, 2006, at 11:31 AM, Ruben Montes ((EU)) wrote:

Hi,

if I'm not using the ccm-manager config and ccm-manager config server  
commands, when I do a change in the CCM MGCP endpoint page and I  
reset the gateway, is this change applied in the gateway?

I want to change the call classification from 'Use system default' to  
'OnNet'. How could I now if changes have been correctly propagated?

Thanks in advance,

Regards,

Ruben

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip