[cisco-voip] Group FXO ports for dial-peers

[Wes Sisk]

trunk group  2
!
voice-port 2/0/4
  trunk-group 2 1
!
voice-port 2/0/5
  trunk-group 2 2
!
voice-port 2/0/6
  trunk-group 2 3
!
voice-port 2/0/7
  trunk-group 2 4
!
dial-peer voice 9 pots
  trunkgroup 2
  destination-pattern 9T
!

/Wes

On Jan 9, 2006, at 1:46 PM, Kris Seraphine wrote:

Hi

I'm configuring an H.323 gateway for a remote site in a CallManager  
4.13 cluster.  This particular site has 12 analog lines in a hunt  
group for PSTN access.  I generally configure separate dial-peers for  
local, longdist, international and emergency calls so I can minimize  
interdigit time out and encorce COR in SRST.  This will work out to  
be over 60 dial peers in this case.

Is there a way to point a POTs dial peer to a group of ports so I can  
reduce the number of dial-peers?  I briefly looked at the trunk-group  
voice-port and dial-peer commands but they do not seem to work for  
what I'm looking to do (or I just didn't have the configuration right).

Any suggestions are appreciated.

-- 
kris seraphine
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060110/4638a02d/attachment.html