[cisco-voip] Clocking on T1 connecting two Routers

[Erick Bergquist]

You need to check with your provider/carrier to see if
they provide clock or not on the circuit. By default,
the router is line clocking which is fine if the
carrier/provider is supplying clock. If they are not,
then on one side you'll need to supply clock on the
T1. 

--- Nasser Khwaja <nkhwaja at gmail.com> wrote:

> Hi,
> I have two routers connected via serial
> point-to-point link; right now it
> works without any clocking commands, but gives
> some CRC errors & carrier transitions -to overcome
> these problems,what is
> the recommended/best clockrate, and needs to be
> set on only one router?
> Thanks
> -Tennisman.
> > _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
> 


"Many of life's failures are people who
did not realize how close they were to
success when they gave up."
                     - Thomas A. Edison

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com