[cisco-voip] Using VWIC-2MFT card with voice and data

[Jason Aarons (US)]

Only issues might be clocking from different sources on the two T1s.
There are clocking limitations on the VWIC2-2MFT-T1/E1.  However in
general it does work, I have lots of sites with this configuration.  

I would try and stick with a WIC1-DSU if you not sure on the telco
clocking -jason

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Chris Ellington
Sent: Monday, July 17, 2006 10:30 AM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] Using VWIC-2MFT card with voice and data

I know it hasn't been supported to use a 2MFT card with one port T1 data
and the other port PRI but I seem to remember seeing a doc stating that
it was supported.

At present, my TAC engineer thinks I nuts and can't find the doc. 

Anyone on the list recall seeing this?

Thanks!

Chris

-- 
Christopher S. Ellington
CCIE #6814
Network Solutions, Inc.
(317) 566 8897
Chris.Ellington at nsi1.com


_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

-----------------------------------------
Disclaimer:

This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the
designated addressee(s) named above only.  If you are not the
intended addressee, you are hereby notified that you have received
this communication in error and that any use or reproduction of
this email or its contents is strictly prohibited and may be
unlawful.  If you have received this communication in error, please
notify us immediately by replying to this message and deleting it
from your computer. Thank you.