[cisco-voip] Using VWIC-2MFT card with voice and data

[Ted Nugent]

Not if it's supported but it does works. Just make
sure you set your clock source to the voice T1 since
it's less tolerant to slips especially for fax.

Also, you're not crazy.. I've seen that doc as well
but I can't seem to find it again, it might have been
corrected or removed from CCO. It don't believe it was
ISR relevant though which seems to be the problem, at
least it was in my case.


--- Chris Ellington <chris.ellington at nsi1.com> wrote:

> I know it hasn't been supported to use a 2MFT card
> with one port T1 data
> and the other port PRI but I seem to remember seeing
> a doc stating that
> it was supported.
> 
> At present, my TAC engineer thinks I nuts and can't
> find the doc. 
> 
> Anyone on the list recall seeing this?
> 
> Thanks!
> 
> Chris
> 
> -- 
> Christopher S. Ellington
> CCIE #6814
> Network Solutions, Inc.
> (317) 566 8897
> Chris.Ellington at nsi1.com
> 
> 
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
> 


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com