[cisco-voip] how to remove a switch from a stack

[Ortiz, Carlos]

Along the same lines, how do you guys monitor a switch in a stack when
it goes down?  Are current Net Management software only polls the IP
address of the stack, but on a couple of occasions we have lost switches
in the stack and didn't know until someone complained.....

 

________________________________

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Ed Leatherman
Sent: Friday, July 21, 2006 1:46 PM
To: James Grace
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] how to remove a switch from a stack

 

I think the commands you want to look at are:
switch# show switch
to see how its configured, and:

switch(config)# switch <number> renumber <number>
Becareful with that command on production switch :) 

On 7/21/06, James Grace <jgrace at digitel.net> wrote:

My 3750 still has the interface numbers showing as the 2nd switch in the
stack  2/0/X.  I reset the switch, everything cleared but the int number


_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip






-- 
Ed Leatherman
Senior Voice Engineer
West Virginia University
Telecommunications and Network Operations 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060721/c03c4ac9/attachment.html