[cisco-voip] Credit Card Machine in a FXS port

[Carter, Bill]

I should find out if it is working to today.  I have a 2801 H.323
12.3(14)T7.  I am pretty sure this is a wiring problem.  The FAX line
works, they are able to swap the FAX and Credit Card lines.  I
re-punched on the 66-block.  I plugged in an analog phone and placed and
received calls.

voice-port 0/1/0
 disconnect-ack
 description FAX
 station-id number xxxxxxxxxx
 caller-id enable
!
voice-port 0/1/1
 description Credit Machine
 station-id number xxxxxxxxxx
 caller-id enable

dial-peer voice 452 pots
 description FAX
 destination-pattern 452
 fax rate disable
 port 0/1/0
!
dial-peer voice 838 pots
 description CreditCard Machine
 destination-pattern 838
 fax rate disable
 port 0/1/1
!
-----Original Message-----
From: Turpin, Mark [mailto:mark.turpin at bryancave.com] 
Sent: Friday, July 28, 2006 3:54 PM
To: Patrick Mowry; cisco-voip at puck.nether.net; Carter, Bill
Subject: RE: [cisco-voip] Credit Card Machine in a FXS port

I've used them before on a VG248.  The major problem was their digit
timing.  They were pulsing in digits about 20msec faster (or something
similar) than what the VG248 would recognize.  The vendor was called in,
reprogrammed the terminals, and everything was fine.

-mark

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Patrick Mowry
Sent: Friday, July 28, 2006 2:43 PM
To: cisco-voip at puck.nether.net; bcarter at sentinel.com
Subject: RE: [cisco-voip] Credit Card Machine in a FXS port

What type of gateway and signalling protocol?  It is not supported on
ATA devices, so I used a 2801.  My PRI lines are on an MGCP gateway, so
I setup the 2801 with MGCP as well.  I added:

mgcp modem passthrough voip mode nse

I don't know if it really was needed or not, but I added it in before
testing the telecheck machines and they worked fine.  The TeleCheck
machines validate checks and credit cards.  So if they worked for me,
they should work for you ;)

-Patrick

----------------------------------------------------------------------
	From: Carter, Bill [mailto:bcarter at sentinel.com] 
	Sent: Monday, July 24, 2006 3:16 PM
	To: cisco-voip at puck.nether.net
	Subject: [cisco-voip] Credit Card Machine in a FXS port

	I am having some funny problems getting a credit card machine
working.  It is plugged into a FXS port on a voice gateway.  Is their
any special configuration parameters required? 
 
This electronic message is from a law firm. It may contain confidential
or privileged information. If you received this transmission in error,
please reply to the sender to advise of the error and delete this
transmission and any attachments.
 
IRS Circular 230 Disclosure: To ensure compliance with requirements
imposed by the IRS, we inform you that any U.S. federal tax advice
contained in this communication (including any attachments) is not
intended or written to be used, and cannot be used, for the purpose of
(i) avoiding penalties under the Internal Revenue Code or (ii)
promoting, marketing, or recommending to another party any transaction
or matter addressed herein.