[cisco-voip] CCM 3.3 MGCP Gateway dial delay

[Brian Henry]

Why do you need all those Dial-Peers with MGCP?
 
If you post the config minus company info we could better understand.
 
CCM 3.3(?) VGW IOS (?)  Device Loads (?)
 
Brian

________________________________

From: cisco-voip-bounces at puck.nether.net on behalf of Voll, Scott
Sent: Wed 5/17/2006 2:26 PM
To: Scott Ingram; cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] CCM 3.3 MGCP Gateway dial delay



Any new route patterns that would cause a interdigit timeout?  You could use DNA or Route report.  

 

Scott

 

________________________________

From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Scott Ingram
Sent: Wednesday, May 17, 2006 7:14 AM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] CCM 3.3 MGCP Gateway dial delay

 

I have started to experience an issue with outside dial patterns.  When a user hits 9 they hear the outside dial tone then + 10 digit number there is a 20 Sec delay before  call  rings destination.  I have done some traces and the call set up and handling seems to be correct.  I have also watched the ISDN debugs and I'm  not finding any errors.  Any Ideas?

IMPORTANT NOTICE:

This message is intended only for the use of the individual or entity to which it is addressed and may contain information that is privileged, confidential and exempt from disclosure under applicable law.  If you have received this message in error, you are hereby notified that we do not consent to any reading, dissemination, distribution or copying of this message.  If you have received this communication in error, please notify the sender immediately and destroy the transmitted information.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060517/a65c25ad/attachment-0001.html