[cisco-voip] IPMA problem or not

Erik Erasmus (E) ErasmuE4 at telkom.co.za
Thu May 18 14:06:06 EDT 2006


Hi

Does anyone have any advice for my IPMA problem. I configured IPMA but
did not use the wizard because I am a bit scared of how it will
combine with my existing CSS and partitions. I use the line device
approach to selectively apply Class of Service to control who can dial
overseas, cell etc. This is done by openeing the CSS on the device to
include all pstn but then on the DNs use blocking CSS routed to a
dummy gateway/ This all works fine.

My IPMA basically have the following:

css_I_E ----- for all user DNs, assistand primary DN, intercom DN on
assistant and manager phone, Manager prim DN
css_M_E ----for proxy dn on assistant phone for a single manager,
Route_point DN with xxxx, CFNA ext and internal

I also have
part_E --- all users, assistt DN, Proxy DN, intercom DN on assistant,
intercom DN on manager
part_I --- CTI RoutPoint DN,
part_M -- Manager DN

assistant user and manager configured etc and associated to their
phones etc.

Problem
========
Assist console starts up, Manager phone shows IPMA window, Assist
console sees manager DN, assistant phone shows interkom and proxy line
on phone etc. Manager phone shows his DN and intercom etc. Assist
console can dial etc.
However - on manager phone the message -- FILTERING DOWN. and also
when phoning the manager DN while assist is active does not intercept
the call even if I have the divert (arrow bouncing of the wall)
activated. I had to leave the site and started reading again to try
nad solve the problem of calls not going to the assistant. The Filter
circle on the manager phone is clear. Is this normal that the
assistant will not then intercept the calls. I am starting to think
when I tested I used the application incorrectly. Should a filter be
on to make things work (I.E meshed. I hope so - and is this a possible
state when the manager have a open filte saying I don;t want fancy
filters but still wants calls to go to my assistant that is active. Am
I on the right track here - configuration is probably correct but when
tested I did not realise that filtering should be one - even if it is
with a open filter for assistants to actually get calls trown to the
proxy line. Will test again tomorrow - any advice will be apprecitade

erik erasmus






~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
This e-mail and its contents are subject to the Telkom SA Limited
e-mail legal notice available at
http://www.telkom.co.za/TelkomEMailLegalNotice.PDF
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060518/60bce8f7/attachment-0001.html 


More information about the cisco-voip mailing list