[cisco-voip] Missed DISCONNECT
Andre Beck
cisco-voip at ibh.net
Tue Nov 14 05:54:18 EST 2006
Hi,
users are complaining about calls to busy external numbers never actually
ringing busy. I tracked it to:
Nov 14 11:31:50.999 CET: ISDN Se2/0:15 Q931: RX <- DISCONNECT pd = 8 callref = 0xC880
Cause i = 0x8091 - User busy
Facility i = 0x91A10C0202917D0606040082670206
Protocol Profile = Remote Operations Protocol
0xA10C0202917D0606040082670206
Component = Invoke component
3PTY Request
Progress Ind i = 0x8288 - In-band info or appropriate now available
Nov 14 11:31:51.003 CET: ISDN Se2/0:15 **ERROR**: isdnAsn1Component: ERROR
Nov 14 11:31:51.003 CET: ISDN Se2/0:15 **ERROR**: process_facility_supp_services: Decode of facility IE operation failed
Nov 14 11:31:51.003 CET: ISDN **ERROR**: Module-CCPRI Function-CCPCC_CallReleasing Error-Unknown event received in message from L3 or Host: D
It appears the DISCONNECT is not acted upon, only when the user later
hangs up the phone is a RELEASE transmit for this callref and a subsequent
RELEASE_COMP received from the carrier.
The PRIs are set up rather straightforward:
interface Serial2/0:15
description Voice PRI#2 to Arcor
no ip address
isdn switch-type primary-net5
isdn overlap-receiving
isdn incoming-voice voice
isdn send-alerting
isdn sending-complete
isdn outgoing display-ie
no cdp enable
[...]
voice-port 2/0:15
translation-profile incoming arcor2-in
translation-profile outgoing arcor2-out
cptone DE
bearer-cap Speech
[...]
dial-peer voice 2 pots
destination-pattern 0T
progress_ind alert enable 8
direct-inward-dial
port 2/0:15
Is this a known problem? Is there a way to tell the gateway to ignore
supposedly defective facility IEs and act upon the obvious request by
the carrier to tear down the call as busy?
TIA,
Andre.
--
The _S_anta _C_laus _O_peration
or "how to turn a complete illusion into a neverending money source"
-> Andre Beck +++ ABP-RIPE +++ IBH Prof. Dr. Horn GmbH, Dresden <-
More information about the cisco-voip
mailing list