[cisco-voip] Missed DISCONNECT
Andrius Kislas
Andrius-conf at elsis.lt
Tue Nov 14 06:05:05 EST 2006
try
voice-port 2/0:15
disc_pi_off
Andrius
Andre Beck wrote:
> Hi,
>
> users are complaining about calls to busy external numbers never actually
> ringing busy. I tracked it to:
>
> Nov 14 11:31:50.999 CET: ISDN Se2/0:15 Q931: RX <- DISCONNECT pd = 8 callref = 0xC880
> Cause i = 0x8091 - User busy
> Facility i = 0x91A10C0202917D0606040082670206
> Protocol Profile = Remote Operations Protocol
> 0xA10C0202917D0606040082670206
> Component = Invoke component
> 3PTY Request
> Progress Ind i = 0x8288 - In-band info or appropriate now available
> Nov 14 11:31:51.003 CET: ISDN Se2/0:15 **ERROR**: isdnAsn1Component: ERROR
> Nov 14 11:31:51.003 CET: ISDN Se2/0:15 **ERROR**: process_facility_supp_services: Decode of facility IE operation failed
> Nov 14 11:31:51.003 CET: ISDN **ERROR**: Module-CCPRI Function-CCPCC_CallReleasing Error-Unknown event received in message from L3 or Host: D
>
> It appears the DISCONNECT is not acted upon, only when the user later
> hangs up the phone is a RELEASE transmit for this callref and a subsequent
> RELEASE_COMP received from the carrier.
>
> The PRIs are set up rather straightforward:
>
> interface Serial2/0:15
> description Voice PRI#2 to Arcor
> no ip address
> isdn switch-type primary-net5
> isdn overlap-receiving
> isdn incoming-voice voice
> isdn send-alerting
> isdn sending-complete
> isdn outgoing display-ie
> no cdp enable
>
> [...]
>
> voice-port 2/0:15
> translation-profile incoming arcor2-in
> translation-profile outgoing arcor2-out
> cptone DE
> bearer-cap Speech
>
> [...]
>
> dial-peer voice 2 pots
> destination-pattern 0T
> progress_ind alert enable 8
> direct-inward-dial
> port 2/0:15
>
>
> Is this a known problem? Is there a way to tell the gateway to ignore
> supposedly defective facility IEs and act upon the obvious request by
> the carrier to tear down the call as busy?
>
> TIA,
> Andre.
More information about the cisco-voip
mailing list