[cisco-voip] Feature Group D Support using MGCP CCM 4.1(3)sr3c

[Patrick Mowry]

Just to throw my 2 cents in,

I could not use FGD with MGCP on a 2800.  Also the format I received
from the carrier in the Phoenix area was not the format cisco wanted
either.  The carrier was sending *ANI*DNIS* and cisco wanted something
like a *XX in front of it were XX was a code to identify something about
the source of the call.  I was told that I could only change what cisco
was looking for on a gateway like to AS5300.  Since the customer was
moving to PRI's in a few weeks,  I ended up using a translation rule to
throw away the extra digits (Including the Caller ID) until they moved
the DID numbers to the new circuits.  I was working on a TCL script to
break it out to the two parts and send the right stuff in the H323 call
setup, but since it would only be for such a short time I never finished
it.

-Patrick

---------- Original Message -----------
From: "Linsemier, Matthew" <MLinsemier at apcapital.com> 
To: "Jose Robles" <jose.robles at netxar.com>, <cisco-voip at puck.nether.net>

Sent: Wed, 4 Oct 2006 10:28:16 -0400 
Subject: RE: [cisco-voip] Feature Group D Support using MGCP CCM
4.1(3)sr3c

> If I remember right, at least through CallManager 4.1(3),fractional
T1?s are not supported with MGCP at this time.? If you wantfractional T1
support you will have to stick with H.323.
> ?
> Matt
> ?
> 
> From:cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] OnBehalf Of Jose Robles
> Sent: Tuesday, October 03, 2006 7:03 PM
> To: cisco-voip at puck.nether.net
> Subject: [cisco-voip] Feature Group D Support using MGCP CCM
4.1(3)sr3c
> ?
> Does anyone knows if E&Mtype fgd is supported using mgcp between
gateways and Callmanager and how Iconfigure it on Callmanager since it
only allows E&M dial-delay and Wink onthe drop down menu of the gateway.
I know it works using H323 but I preferusing mgcp. 
> 
> ds0-group 0 timeslots 1-12 type e&m-fgd 
> 
> Thanks in advance to all... 
> 
> 
>