[cisco-voip] H.323 endpoints

[Simon, Bill]

This makes sense.  Does it use the same ports for the audio path as 
skinny?


Wes Sisk wrote:
> Bill,
> 
> Yeah, not much out there.  point your h323 client (netmeeting) to the IP 
> of CM.  CM listens on tcp:1720 - standard TCP port for h323 call setup 
> (note this is not the RAS port, UDP:1719).  In CM define the netmeeting 
> client either by IP address or by hostname.  If you define by hostname 
> then CM must be able to resolve that name to the correct IP of the 
> client PC.  Configure the client as an h323 phone in CM.
> 
> /Wes
> 
> Simon, Bill wrote:
>> I'm thinking about using an H.323 soft client with CallManager and 
>> finding the documentation to be sparse.  Or maybe I just don't know 
>> where to look.  Is there a specific setup guide for H.323 protocol 
>> (endpoints) with CallManager?
>>
>> A generic question... is there any way to set up H.323 endpoints 
>> without a gatekeeper?  Would there be any value in this or would it 
>> mean dialing by IP address?
>>
>>
>>   

-- 
Bill Simon - bills at tns.its.psu.edu - (814) 865-2270
http://tns.its.psu.edu/