[cisco-voip] H.323 endpoints

[Wes Sisk]

Bill,

Yeah, not much out there.  point your h323 client (netmeeting) to the IP 
of CM.  CM listens on tcp:1720 - standard TCP port for h323 call setup 
(note this is not the RAS port, UDP:1719).  In CM define the netmeeting 
client either by IP address or by hostname.  If you define by hostname 
then CM must be able to resolve that name to the correct IP of the 
client PC.  Configure the client as an h323 phone in CM.

/Wes

Simon, Bill wrote:
> I'm thinking about using an H.323 soft client with CallManager and 
> finding the documentation to be sparse.  Or maybe I just don't know 
> where to look.  Is there a specific setup guide for H.323 protocol 
> (endpoints) with CallManager?
>
> A generic question... is there any way to set up H.323 endpoints without 
> a gatekeeper?  Would there be any value in this or would it mean dialing 
> by IP address?
>
>
>