[cisco-voip] Jitter - Codec issue?
Linsemier, Matthew
MLinsemier at apcapital.com
Thu Oct 26 14:38:36 EDT 2006
Remember that your Max Jitter is just that, the maximum Jitter for the
entire call. Your average jitter looks pretty normal for a WAN link.
What type of link is this again? Is this a Internet or WAN related
link? If you are using Cisco routers you could enable some IP SLA
responders to dig deeper into the problem. It will tell you if you are
dropping packets, receiving out of order packets, and a load of other
informative data by sending test packets across the link.
Matt
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Howard, Chad
Sent: Thursday, October 26, 2006 2:28 PM
To: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Jitter - Codec issue?
RxType=G.729
TxType=G.729
RxSize=10
TxSize=20
Avg Jitter=8
Max Jitter=274
RxDisc=0
RxLost=1
TAC said inbound packet loss could cause the RxSize to be lower. The
phone didn't show much loss, but jitter was high.
________________________________
From: Louis Marascio (lmarasci) [mailto:lmarasci at cisco.com]
Sent: Thursday, October 26, 2006 9:58 AM
To: Howard, Chad; cisco-voip at puck.nether.net
Subject: RE: [cisco-voip] Jitter - Codec issue?
Non matching values should not be a problem as far as I know. What
codec does the info page show? How many packets are being lost,
discarded, and what does the phone report as the avg & max jitter?
Thanks,
Louis
________________________________
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Howard, Chad
Sent: Wednesday, October 25, 2006 3:39 PM
To: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Jitter - Codec issue?
We have some users experiencing choppy voice - I think related to
jitter, but I don't know the actual cause.
During an active call I pressed the ? key twice to get the stats.
It shows the "RxSize: 10ms" and the "TxSize: 20ms". I've seen issues
with that before (I think they need to match). Anyone know how those
parameters get set, and if non-matching values are in fact a problem?
Thanks much.
Chad
CONFIDENTIALITY STATEMENT
This communication and any attachments are CONFIDENTIAL and may
be protected by one or more legal privileges. It is intended
solely for the use of the addressee identified above. If you
are not the intended recipient, any use, disclosure, copying
or distribution of this communication is UNAUTHORIZED. Neither
this information block, the typed name of the sender, nor
anything else in this message is intended to constitute an
electronic signature unless a specific statement to the
contrary is included in this message. If you have received this
communication in error, please immediately contact me and delete
this communication from your computer. Thank you.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20061026/0971a44a/attachment.html
More information about the cisco-voip
mailing list