[cisco-voip] SRST transfer user 4 digits to an 11 digit extension

[Ryan Ratliff]

I haven't played with the transfer-pattern config too much so I'm not  
sure what affect that would have on this behavior.

Have you tried applying the translation-profile to a pots dial-peer  
with a destination-pattern of 2...$?

How about running a 'debug voice translation' to see if it's getting  
applied?

-Ryan

On Sep 2, 2006, at 11:17 AM, STEVEN CASPER wrote:


  We use 11 digit extensions at our site and would like to be able to
transfer using 4 digits when in SRST mode just as can be done when not
in SRST. Transfer works fine to an the actual 11 digit extension but we
have not been able to figure out how to allow a 4 digit transfer. Here
is the SRST config:

call-manager-fallback
  max-conferences 4 gain -6
  transfer-system full-blind
  ip source-address 10.120.224.1 port 2000 strict-match
  max-ephones 40
  max-dn 80 dual-line
  transfer-pattern 1716849....
  transfer-pattern 2...
  voicemail 914103476301
  translation-profile incoming 2
  translation-profile outgoing 2
  call-forward busy 17168492502
  call-forward noan 17168492501 timeout 16
  time-zone 12

and the associated translation

voice translation-rule 2
  rule 1 /^\(2...\)$/ /1716849\1/

voice translation-profile 2
  translate calling 2
  translate called 2

The translation rule is good because inbound 4 digit DID works when in
SRST, any advice would be appreciated.





Thanks!

Steve Casper
Voice Technologies
M&T Bank
(410) 347-6026

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip