[cisco-voip] busy out PRI

[Melvin Fong]

Does anyone know of a way to busy out a PRI using call manager?
I don't see anything on the gateway config.  The only way I know of is
to busy the port that is connected to the PRI.  The question is whether
CM will recognize the circuit as not usable. If the port is disabled
then the D link should go down and hopefully CM will send the calls to
the 2nd PRI on the route list.  I haven't tested this yet and hoped
someone else has already.  Thanks
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060920/8b3ac7f1/attachment.html