[cisco-voip] busy out PRI

[Ryan Ratliff]

Take a look at the description for the advanced CM service parameter  
"Change B-Channel Maintenance Status".
This is for MGCP PRIs only of course.  For H.323 it's all done in IOS.

-Ryan

On Sep 20, 2006, at 12:25 PM, Melvin Fong wrote:

Does anyone know of a way to busy out a PRI using call manager?
I don't see anything on the gateway config.  The only way I know of  
is to busy the port that is connected to the PRI.  The question is  
whether CM will recognize the circuit as not usable. If the port is  
disabled then the D link should go down and hopefully CM will send  
the calls to the 2nd PRI on the route list.  I haven't tested this  
yet and hoped someone else has already.  Thanks
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip