[cisco-voip] Updating the E911 database

[Robert Kulagowski]

We're consolidating offices in NY; two offices will move into the same 
building onto different floors.

ATT is going to be our LD and Local provider (last mile is probably 
Verizon).  We use Cisco Emergency Responder.  In Illinois, you used to 
be able to tell Ameritech "These DIDs are on floor X, and these are on 
floor Y", configure the ELINs in CER to route to those particular DIDs 
and you were good.

In NY, ATT says they don't do that, and that you have to contact a 3rd 
party to get the information updated in the PSAP database.

Since I'm going to use two DIDs per floor, that means that I need four 
all together.  Two of them should already show that they're on floor X - 
I need to get the remaining two to show that they're on floor Y.

ATT sent a Word doc that had 911 ETC, Redsky and OM2 Technology as SLI 
(Station-level Identification) vendors.  Since I've already got CER, are 
there any vendors that will just update the two numbers and call it a 
day?  The one response that I've got back is something like $3K, and 
then another $312 monthly, which seems pretty steep for something that's 
not going to change.  They all seem to be geared around doing 
moves-adds-changes and updating the PSAP, which isn't required with CER.

Does anyone have any other vendors that do these database updates?  Am I 
doing this the hard way if there's a much cheaper / easier way to do this?