[cisco-voip] Dial Peer Matching

[STEVEN CASPER]

 Installed a site tonight with analog FXO trunks controlled via MGCP.
Outbound calls worked fine but inbound did not. Looking at a debug of
the dial peers I could see that the inbound calls were matching the
dial
peers that were built for SRST. These were in front of the MGCP dial
peers in the router config.

 Removed  the SRST dial peers and inbound worked fine. Added them back
in and inbound still works ok Now they are after the MGCP dial peers
in
the config. Are dial peers searched on a hierarchical basis? I would
have thought that because the FXO ports were controlled by MGCP the
dial
peers configured for SRST would not have been used.



Thanks!

Steve Casper
Voice Technologies
M&T Bank
(410) 347-6026

************************************
This email may contain privileged and/or confidential information that is intended solely for the use of the addressee.  If you are not the intended recipient or entity, you are strictly prohibited from disclosing, copying, distributing or using any of the information contained in the transmission.  If you received this communication in error, please contact the sender immediately and destroy the material in its entirety, whether electronic or hard copy.  This communication may contain nonpublic personal information about consumers subject to the restrictions of the Gramm-Leach-Bliley Act and the Sarbanes-Oxley Act.  You may not directly or indirectly reuse or disclose such information for any purpose other than to provide the services for which you are receiving the information.
There are risks associated with the use of electronic transmission.  The sender of this information does not control the method of transmittal or service providers and assumes no duty or obligation for the security, receipt, or third party interception of this transmission.
************************************