[cisco-voip] VGW not registered in CCM but is on GW

[Lelio Fulgenzi]

I believe all layers have to be up before it will show registered on CallManager. But it will show connected to CallManager subscribers in the show ccm on the router as long as data connectivity from the router to the subscribers is available.

That is what I experienced.

You can try a cross-over cable between two local ports to simulate SP connectivity or a loopback might work as well.

http://www.ciscohq.com/FAQs/Cisco-FAQs/Building-T1-Looback-and-Crossover-Cable.html
--------------------------------------------------------------------------------
Lelio Fulgenzi, B.A.
Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1
(519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ 
"Buffalo buffalo Buffalo buffalo buffalo buffalo Buffalo buffalo."      WJR
  ----- Original Message ----- 
  From: Scott Voll 
  To: cisco-voip at puck.nether.net 
  Sent: Wednesday, August 01, 2007 11:50 AM
  Subject: [cisco-voip] VGW not registered in CCM but is on GW


  I have a 3845 running 12.4(15)T1 via MGCP to the CM 5.1.2.

  on the VGW a show ccm shows registered but on the CM is shows the correct IP address but unregistered.

  I have the service MGCPapp command on my dial-peers  and all the normal ccm-manager commands along with MGCP commands.

  is it not registered because I don't have anything plugged into the PRI ports?

  TIA

  Scott


------------------------------------------------------------------------------


  _______________________________________________
  cisco-voip mailing list
  cisco-voip at puck.nether.net
  https://puck.nether.net/mailman/listinfo/cisco-voip
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070801/d57d2733/attachment.html