[cisco-voip] Polycom SE200 H.323 Gatekeeper w/ CCM 4.1(3)

[Matthew Saskin]

If the Polycom VSX endpoints are relying on the gatekeeper, you'd have 
to put dial plan information into the gatekeeper config:

gatekeeper
   zone local ......
   zone local callmanager ....
   zone prefix callmanager 9*

This will make the gatekeeper send ARQs that begin with the digit 9 
towards the "callmanager" zone, which is the zone the ccm trunk 
registers itself to.  I'm not sure of any other way to do this since CCM 
doesn't provide the ability to register it's dial plan (or parts of the 
dial plan) with a gatekeeper like voice gateways do.

-matt

Dave Wolgast wrote:
> I'm hoping someone out there has some experience with this platform...I 
> have established a Gatekeeper-controlled H.323 trunk with the SE200, and 
> can now make audio calls to my Polycom VSX endpoints.  What I don't know 
> how to do is to set up dialing in the other direction (VSX -> CCM 
> endpoints).
>  
> The system was configured with a single site.  Do I need to add a site 
> in order to make this happen?  Where do I put dial-plan information (If 
> 1000 is dialed, send to the H.323 trunk, etc...).
>  
> Any help is greatly appreciated.
> 
> -- 
> Dave Wolgast
> Livonia, NY
> 
> 
> ------------------------------------------------------------------------
> 
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip