[cisco-voip] VMWI on analog phones with VG224

[Ahmed Elnagar]

Hello kenneth;

Thanks for your reply, the problem was that the VG224 only supports FSK
with 24 or 48 volt and the analog phone that I was testing was using 90
volt by default, this phone works well with the VG248 as it supports
this high voltage but not the VG224.

 

________________________________

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Kenneth
Sinfield
Sent: Tuesday, August 07, 2007 12:37 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] VMWI on analog phones with VG224

 

Hi Ahmed,

 

I have VMWI working on an ISR router with FXS ports (VMWI will work on a
VG224 as well). Basically below are the requirements:

 

*         The Cisco Gateway must run IOS version IP Voice T strain (not
SP Services on ISRs) 12.4(6)T or later (I tested 12.4(11)T2)

*         Cisco CallManager version must be version 4.2 or later (I
tested CallManager 5.1.2)

*         Any version of Unity (I tested Unity Connection 1.2)

*         Must use SCCP(Skinny) as the gateway protocol, and NOT MGCP

 

Here is an output from the gateway(MWI refers to stutter tone VMWI needs
to be "ON"):

 

pstn#show stcapp device voice-port 0/3/3

Port Identifier:  0/3/3

Device Type:      ALG 

Device Id:        4

Device Name:      AN17598075F0183

Modem Capability: None

Device State:     IS

Diagnostic:       None

Directory Number: 1005

Dial Peer(s):     101 

Dialtone after remote onhook feature: activated

Last Event:       STCAPP_CC_EV_CALL_DISCONNECT_DONE

Line State:       IDLE

Hook State:       ONHOOK

mwi:              ENABLE

vmwi:             ON

PLAR:             DISABLE

Number of CCBs:   0

Global call info:

    Total CCB count      = 0

    Total call leg count = 0

 

Thanks,

Ken.

 

Kenneth Sinfield

Systems Engineer

Dimension Data, Australia

139 Coronation Drive, Milton

Queensland, Australia, 4064

Phone: +61732921968

 

************************************************************************
******

- NOTICE FROM DIMENSION DATA AUSTRALIA

This message is confidential, and may contain proprietary or legally
privileged information. If you have received this email in error, please
notify the sender and delete it immediately.

 

Internet communications are not secure. You should scan this message and
any attachments for viruses. Under no circumstances do we accept
liability for any loss or damage which may result from your receipt of
this message or any attachments.

************************************************************************
******

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070808/4514663b/attachment-0001.html