[cisco-voip] Intl Calls with Verizon in Philadelphia area

[Ted Nugent]

I had similar issues a few weeks back with an H323
gateway and tried leaving plan type as is (defaulting
to international like yours) and just striping the 011
and for whatever reason I was still getting the error.
Eventually I ended up using translation profiles to
change the plan and that worked.

voice translation-rule 1
 rule 1 /^9011/ /011/ type any national plan any isdn
!
voice translation-profile pstn-out
 translate called 1
!
dial-peer voice 30 pots
 translation-profile outgoing pstn-out
 destination-pattern 9011T
 port 0/0/0:23
 forward-digits all




--- CarlosOrtiz at bayviewfinancial.com wrote:

> I am not able to send International calls through
> our PRI's at a location 
> outside of Philly.  Local and LD work fine.  debugs
> at the router show the 
> number being sent to the telco are fine. 
> 
> Debug ISDN q931
> 
> Calling Party Number i = 0x2181, '215664XXXX' 
>                 Plan:ISDN, Type:National 
>         Called Party Number i = 0x91,
> '011448458787000'
> 
> I found a CCO TAC case where this exact problem is
> described and addressed 
> by changing the calling plan type from national to
> unknown using the 
> following command under the D channel interface.
> 
> isdn map address .* plan isdn type unknown
> 
> This did in fact change the plan type but I was
> unable to complete local, 
> LD and Intl after adding this.
> 
> Any suggestions?
> 
> Carlos
> 
> 
> 
> 
> 
> 
> 
> > _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip



       
____________________________________________________________________________________
Building a website is a piece of cake. Yahoo! Small Business gives you all the tools to get online.
http://smallbusiness.yahoo.com/webhosting