[cisco-voip] RightFax

[Joel Perez]

Hey Guys,

I seem to have hit a stumbling block setting up a RightFax server V9.3 and a
Brooktrout TR1034 card.
I cant get the T-1 to come up.
The way its set up is the BrookTrout card goes to a VWIC2-2MFT-T1/E1-T1 port
on my 2851.
I am using CUCM 5.1.1 and MGCP on that T1 port on the 2851. My config on the
2851 is as follows.

controller T1 0/1/1
 framing esf
 clock source internal
 linecode b8zs
 pri-group timeslots 1-24 service mgcp
!

interface Serial0/1/1:23
 no ip address
 isdn switch-type primary-4ess
 isdn protocol-emulate network
 isdn incoming-voice voice
 isdn bind-l3 ccm-manager
 no cdp enable


On the Brooktrout card on the "PortA" tab I have the following:
Switch Type : AT&T #4 ESS
Protocol (Variant):  Bellcore national ISDN-1 Standard
Emulation: CPE
Line Coding B8ZS

On the "Clock settings" tab i have:
Clock Mode: Master
Clock Source : Network Trunk Port A
Clock Compatibility: None


I tried getting their Tech support to help but they pointed fingers at the
CUCM and said they couldnt help me any further.

Thanks,

Joel P
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20071228/3f541bf1/attachment.html