[cisco-voip] H.323 Gateway PRI selection

[Gurpinder Thaliwal]

One idea maybe to have 3 route patterns in CCM eg.

91.@

92.@

93.@

Representing each of the CLIDs.  Then on the H323 gateway you can create 3
(or 4 if you count the 2 PRI's with the same number) pots dial peers which
point to the corresponding voice port.

 

This will allow your users to 'select' which CLID to present.

 

If the specific users will always use specific CLID's then you need a
different CSS for each.

 

 

  _____  

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of
CarlosOrtiz at bayviewfinancial.com
Sent: 06 June 2007 19:24
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] H.323 Gateway PRI selection

 


We have a new H.323 Gateway that will have 4 PRI's.  2 PRI's will be grouped
together and present one caller  ID.  Each of the remaining 2 PRI's will
have their own caller ID (3 total different Caller ID's).  How can you
select a specific PRI to be used so that the correct caller ID is shown
depending on which phone dials outboud?  I should be able to prepend a digit
on Call Mgr to the 3 different route patterns (different partitions) and
then route the call based on the leading digit found on the H.323 GW.  I
know I can do this via MGCP easily as well.  Any other good ideas or
thoughts about this via H.323? 

Carlos

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070606/e29cf163/attachment.html