[cisco-voip] H.323 Gateway PRI selection

[Lelio Fulgenzi]

Wouldn't you do this with the dial-peers?

There is a caller ID config statement that you can configure, then select the appropriate port.

--------------------------------------------------------------------------------
Lelio Fulgenzi, B.A.
Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1
(519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ 
"Buffalo buffalo Buffalo buffalo buffalo buffalo Buffalo buffalo."      WJR

  ----- Original Message ----- 
  From: CarlosOrtiz at bayviewfinancial.com 
  To: cisco-voip at puck.nether.net 
  Sent: Wednesday, June 06, 2007 2:24 PM
  Subject: [cisco-voip] H.323 Gateway PRI selection



  We have a new H.323 Gateway that will have 4 PRI's.  2 PRI's will be grouped together and present one caller  ID.  Each of the remaining 2 PRI's will have their own caller ID (3 total different Caller ID's).  How can you select a specific PRI to be used so that the correct caller ID is shown depending on which phone dials outboud?  I should be able to prepend a digit on Call Mgr to the 3 different route patterns (different partitions) and then route the call based on the leading digit found on the H.323 GW.  I know I can do this via MGCP easily as well.  Any other good ideas or thoughts about this via H.323? 

  Carlos


------------------------------------------------------------------------------


  _______________________________________________
  cisco-voip mailing list
  cisco-voip at puck.nether.net
  https://puck.nether.net/mailman/listinfo/cisco-voip
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070606/b5dcc80a/attachment.html