[cisco-voip] H.323 Gateway PRI selection

[CarlosOrtiz at bayviewfinancial.com]

Basically I need 3 different groups of users always to use their 
designated PRI's so that the correct caller ID is presented.   Think of it 
as 3 companies sharing one gateway, each desginated to a PRI with that 
companies name and number on it. 

In response to the Gurpinder's post....I do not need them to select which 
caller id they want to use.  Each of the 3 groups will always use the same 
caller ID.  I had an idea similar to yours to prepend digits so that when 
the call gets to the gateway I know which PRI it needs to exit from. I 
just want to make sure I don't miss an easier method.

Carlos




"Lelio Fulgenzi" <lelio at uoguelph.ca> 
Sent by: cisco-voip-bounces at puck.nether.net
06/06/2007 03:50 PM

To
<cisco-voip at puck.nether.net>, <CarlosOrtiz at bayviewfinancial.com>
cc

Subject
Re: [cisco-voip] H.323 Gateway PRI selection






Wouldn't you do this with the dial-peers?
 
There is a caller ID config statement that you can configure, then select 
the appropriate port.
 
--------------------------------------------------------------------------------
Lelio Fulgenzi, B.A.
Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1
(519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ 
"Buffalo buffalo Buffalo buffalo buffalo buffalo Buffalo buffalo." WJR
----- Original Message ----- 
From: CarlosOrtiz at bayviewfinancial.com 
To: cisco-voip at puck.nether.net 
Sent: Wednesday, June 06, 2007 2:24 PM
Subject: [cisco-voip] H.323 Gateway PRI selection


We have a new H.323 Gateway that will have 4 PRI's.  2 PRI's will be 
grouped together and present one caller  ID.  Each of the remaining 2 
PRI's will have their own caller ID (3 total different Caller ID's).  How 
can you select a specific PRI to be used so that the correct caller ID is 
shown depending on which phone dials outboud?  I should be able to prepend 
a digit on Call Mgr to the 3 different route patterns (different 
partitions) and then route the call based on the leading digit found on 
the H.323 GW.  I know I can do this via MGCP easily as well.  Any other 
good ideas or thoughts about this via H.323? 

Carlos 

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070606/3121c1e1/attachment.html