[cisco-voip] CME shared ephone-dn question

[Jonathan Charles]

Change the button commands to:

button 1o1,2

This way 1000 will ring both phones.and the third call will go to the
call-forward busy location.




Jonathan

On 6/7/07, Jeff Anderson (Enventis) <janderson at enventis.com> wrote:
> I want to configure the following setup. Two shared lines on two
> different buttons. Each ephone-dn accepts one inbound call supporting a
> total of two calls. When the third call comes in I want it to go to VM.
>
> This is what I have:
>
> ephone-dn 1 dual-line
>         number 1000
>         label Main Line 1
>         Preference 1
>         huntstop-channel
>         call-forward busy 2098
>         call-forward noan 2098 timeout 18
>         no huntstop
>
> ephone-dn 2 dual-line
>         number 1000
>         label Maine Line 2
>         preference 2
>         huntstop-channel
>         call-forward busy 2098
>         call-forward noan 2098 timeout 18
>
> Ephone 1
> Button 1:1 2:2
>
> Ephone 2
> Button 1:1 2:2
>
> 2098 is VM pilot.
>
>
> In the above scenario that call only rings in on one ephone-dn and goes
> to VM. If I setup ephone-dn 1 to call-forward busy to 1000 it rings busy
> on the third call.
>
> Can someone please send me a configuration example of what I am trying
> to accomplish.
>
> Thanks
>
> Jeff
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>