[cisco-voip] Tone on Hold [triple beep] HOW TO

[Jefflin Choi]

Is this good for CCM4/CCM5 or both?

On 6/17/07, Paul Choi <asobihoudai at yahoo.com> wrote:
>
> [at least in my case]
>
> Disable all MoH servers by changing their run state to
> "No" and then modify
>
> Service -> Service Parameters -> Cisco CallManager ->
> Send  H.225 User Message parameter from its default to
> H.225 Info for Call Progress Tone.
>
> This was difficult to fix as disabling MoH would give
> us dead air without this service parameter
> modification. If any of you are pulling your hair out
> over this, try to modify this parameter and you should
> be good to go assuming you're using an H.323 environment.
>
>
>
>
> ____________________________________________________________________________________
> Be a better Heartthrob. Get better relationship answers from someone who
> knows. Yahoo! Answers - Check it out.
> http://answers.yahoo.com/dir/?link=list&sid=396545433
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070625/51293329/attachment.html