[cisco-voip] Valcom Configuration

[Steve G]

for FXO H.323  to 2003-A configuration...

voice-port X/X/X
 pre-dial-delay 0

dial-peer voice XXXX pots
 max-conn 1
 destination-pattern 999[1-3]
 port x/x/x
 forward-digits 1



On 6/22/07, Jason Aarons (US) <jason.aarons at us.didata.com> wrote:
>
>  The lack of disconnect supervision in V9970 makes this a poor design, I
> would swap it out with a V2003 and plug it into a FXO port. With the V9970
> you risk the paging horn being stuck offhook until you either reset the port
> or reset the V9970. Could be rare, but still annoying!
>
>
>
> *From:* cisco-voip-bounces at puck.nether.net [mailto:
> cisco-voip-bounces at puck.nether.net] *On Behalf Of *Carter, Bill
> *Sent:* Friday, June 22, 2007 5:43 PM
> *To:* Ocampo, Walter; cisco-voip at puck.nether.net
> *Subject:* Re: [cisco-voip] Valcom Configuration
>
>
>
> it is an Analog (FXS) connection to the V-9970.  It is just a DN on the
> analog port.
>
>
>  ------------------------------
>
> *From:* cisco-voip-bounces at puck.nether.net [mailto:
> cisco-voip-bounces at puck.nether.net] *On Behalf Of *Ocampo, Walter
> *Sent:* Friday, June 22, 2007 8:14 AM
> *To:* cisco-voip at puck.nether.net
> *Subject:* [cisco-voip] Valcom Configuration
>
> I had a remote location that has Valcom V-9970 and V-2003A 3 Zone
> Enhanced, One-Way Power Built-In. They are not using it but it is installed.
> We are going to install a Gateway with 1 PRI card, 2 FXS and 2 FXO ports-
> MGCP-Call manager 4.1(3).
>
> This is the first time I am going to adhere this devices to work in our
> VoIP system. Any idea how I have to configure the gateway and call manager
> to have this project working?
>
> Any help will be appreciate.
>
>
>
> Regards,
>
>
>
>
>
> Walter Ocampo
>
> System Network Analyst
>
> Office of Information Technology
>
> 540 S.E 3rd. Ave, Suite 300
>
> Fort Lauderdale, FL 33301
>
> (954) 357 8041 Cell (954) 632 8228
>
> wocampo at broward.org
>
>
>
> ------------------------------
>
> *Disclaimer: This e-mail communication and any attachments may contain
> confidential and privileged information and is for use by the designated
> addressee(s) named above only. If you are not the intended addressee, you
> are hereby notified that you have received this communication in error and
> that any use or reproduction of this email or its contents is strictly
> prohibited and may be unlawful. If you have received this communication in
> error, please notify us immediately by replying to this message and deleting
> it from your computer. Thank you. *
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070625/56e4770c/attachment.html