[cisco-voip] 2801 MGCP Gateway on CCM 5.0

[Jonathan Charles]

In CCM, you need to setup the gateway name as:

GW2801.test.br

This is your hostname and your ip domain name...

There is no other method.

When you say it is 'active' on the gateway, that doesn't correspond to what
it should say...

If you do a:

show ccm

you should see it say primary and registered.

And then on CCM, click on show endpoints and you should see a 'registered
with...' if it is up.


Jonathan


On 2/28/07, alsvrj <alsvrj at superig.com.br> wrote:
>
> Hello All,
>
> I have an 2801 connected to a Hicom 330 PBX through a ISDN PRI QSIG with
> MGCP and a CCM5.0. I´m having a lot of problems to get the gateway
> registration on CCM.
>
> I would like to do some questions:
> 1- Is it possible to put an ISDN PRI with MGCP using QSIG signaling ?
>
> Using the show isdn status command I´m seeing MULTIPLE_FRAME_ESTABILISHED
>
> I´m seeing too with the show ccm-manager that the MGCP is Active but I´m
> not
> able to see this Gateway into the active state inside of CCM.
>
> I´m using a VWIC-1MFT-E1 card to use this ISDN PRI.
>
> 2- Is it possible to put the IP Address instead of Domain Name when I´m
> creating the 2801 Gateway ?
>
> Hey guys, I really need your help to solve this registration problem, I
> kindly ask a hand into this situation.
>
> Thanks for everything.
>
> It follows below the configuration on the Gateway:
>
> hostname GW2801
> !
> boot-start-marker
> boot system flash c2801-adventerprisek9-mz.124-6.T3.bin
> boot-end-marker
> !
> logging buffered 4096 informational
> enable secret 5 ********************
> !
> no aaa new-model
> !
> resource policy
> !
> clock timezone UTC -3
> network-clock-participate wic 2
> network-clock-select 1 E1 0/2/0
> ip cef
> !
> !
> !
> !
> ip tcp synwait-time 13
> no ip domain lookup
> ip domain name test.br
> ip name-server *.*.*.*
> ip name-server *.*.*.*
> ip name-server *.*.*.*
> !
> isdn switch-type primary-qsig
> isdn logging
> !
> voice-card 0
> dsp services dspfarm
> !
> !
> voice call carrier capacity active
> !
> !
> voice class codec 1
> codec preference 1 g711ulaw
> codec preference 2 g729r8 bytes 40
> !
> !
> !
> voice class h323 1
> h225 timeout tcp establish 3
> !
> crypto configuration
> !
> controller E1 0/2/0
> framing NO-CRC4
> line-termination 75-ohm
> pri-group timeslots 1-31 service mgcp
> !
> !
> interface FastEthernet0/0
> ip address *.*.*.* *.*.*.*
> speed 100
> full-duplex
> no cdp enable
> h323-gateway voip bind srcaddr *.*.*.*
> !
> interface FastEthernet0/1
> no ip address
> shutdown
> duplex auto
> speed auto
> no cdp enable
> !
> interface Serial0/1/0
> no ip address
> shutdown
> clock rate 2000000
> no cdp enable
> !
> interface Serial0/2/0:15
> no ip address
> no ip proxy-arp
> encapsulation hdlc
> isdn switch-type primary-qsig
> isdn overlap-receiving
> isdn incoming-voice voice
> isdn supp-service name calling
> isdn bind-l3 ccm-manager
> isdn negotiate-bchan
> isdn bchan-number-order ascending
> isdn sending-complete
> no cdp enable
> !
> ip route 0.0.0.0 0.0.0.0 *.*.*.*
> !
> !
> ip http server
> ip http secure-server
> !
> logging *.*.*.*
> access-list 1 permit *.*.*.*
> access-list 1 permit *.*.*.*
> dialer-list 1 protocol ip permit
> snmp-server community voip RW 1
> snmp-server community ext0399 RW 1
> snmp-server community sw0399 RW 1
> disable-eadi
> no cdp run
> !
> control-plane
> !
> voice-port 0/2/0:15
> !
> ccm-manager mgcp
> ccm-manager music-on-hold
> ccm-manager config server *.*.*.*
> ccm-manager config
> !
> mgcp
> mgcp call-agent *.*.*.* 2427 service-type mgcp version 0.1
> mgcp dtmf-relay voip codec all mode out-of-band
> mgcp rtp unreachable timeout 1000 action notify
> mgcp modem passthrough voip mode nse
> mgcp package-capability rtp-package
> no mgcp package-capability res-package
> mgcp package-capability sst-package
> no mgcp package-capability fxr-package
> mgcp package-capability pre-package
> no mgcp timer receive-rtcp
> mgcp sdp simple
> mgcp fax t38 inhibit
> mgcp rtp payload-type g726r16 static
> !
> mgcp profile default
> !
> !
> dial-peer cor custom
> !
> !
> !
> dial-peer voice 1 pots
> service mgcpapp
> port 0/2/0:15
> !
> !
> !
> line con 0
> exec-timeout 0 0
> password 7 *****************
> logging synchronous
> login
> line aux 0
> exec-timeout 0 0
> password 7 *****************
> logging synchronous
> login
> line vty 0 4
> exec-timeout 0 0
> password 7 **************
> logging synchronous
> login
> !
> scheduler allocate 20000 1000
> ntp clock-period 17180079
> ntp server *.*.*.*
> !
> webvpn context Default_context
> ssl authenticate verify all
> !
> no inservice
> end
>
>
>
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070302/1843e0bf/attachment-0001.html