[cisco-voip] Outbound call routing

[Matthew Saskin]

My guess is you're running debug commands from a non-console session 
[i.e.; telnet/ssh].  Remember to enable terminal monitoring ('term mon' 
from enable mode).  Without it all your debugs will only get spit out 
the console port.

-matt

James Williams wrote:
>> If you're using MGCP it's all up to callmanager.  Using the 8.@ pattern 
>> to match and discarding predot, prepending the access code (9200?) 
>> should do the trick.  Is it the lack of a pause between access code and 
>> dial string that's tripping up the PBX?
>>     
>
> I believe so, but I'm not 100% sure. For some reason, debug commands on this router are outputting _no_ data whatsoever, so I can't even track down where the problem is occurring. 
>
> -James
>
>
>