[cisco-voip] CUE-AIM 2.3-CCM:after running the wizard it continously reloads

[Kris Seraphine]

Is it a brand new AIM module?  I've seen them get stuck in a reboot cycle
when the flash disk gets too full.  The solution to that is to download the
helper image from CCO and put it on tftp.  Go to bootloader prompt (hit ***
when prompted during boot) and change config to point to this helper. Boot
this image by doing a "boot helper".  When the image boots up, choose Option
3 to do disk cleanup.

That might be worth a try.


It might also help to post an error messages you see when it's stuck in the
reboot cycle.



On 3/30/07, Anthony Kouloglou <akoul at dataways.gr> wrote:
>
> Hi, i have a CUE AIM 2.3 on a 2811 and i integrated it with a CCM 5.0(4a).
> After running the 1 wizard to configure it, i also run the
> postinstallation wizard: it went OK.
> Then i accessed the GUI and performed the wizard to import users etc.
> i have filled the necessary information, jtapi user, ccmadmin user and
> the wizard imported all the settings correctly (i have skipped the users
> import because for the moment i only need the AA).
> After that, i saw the gui and the CTI ports were correctly imported,
> but...
>
> it started to reload!
> And after it came online, it reloaded again!
> And every time it came online, after 10-15 seconds it reloads.
> I almost had the time to issue "offline" and "restore factory defaults"
> and after the reload i am back to zero again.
> I did the same procedure and it happened again!!
> Any ideas why it is happening?
>
> Thanks
> Anthony
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>



-- 
kris seraphine
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070330/4752054b/attachment.html