[cisco-voip] codec complexity flex command

[pedro marques]

Lelio,

If your hardware is using the C5510 chipset I believe the default mode would
be flex mode. Anyhow the command 'show voice dsp voice' will show what
chipset(s) is being used on the hardware.

On 10/05/07, Lelio Fulgenzi <lelio at uoguelph.ca> wrote:
>
>  I tried entering the "codec complexity flex" command under my voice-card
> and although it took it, when I do a show run, it only comes up with the
> following:
>
> voice-card 0
>  no dspfarm
>
> Is the flex code the default? What show command can I use to verify that
> flex is being used?
>
>
> --------------------------------------------------------------------------------
> Lelio Fulgenzi, B.A.
> Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1
> (519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
> ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
> ...there's no such thing as a bad timbit...
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>


-- 
Pedro Miguel Marques
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070510/dd5f7f26/attachment.html