[cisco-voip] H323 Gateway and 0X3A Bearer Capability Not Available

Kalle Tetto tettokalle at hotmail.com
Tue May 22 14:54:26 EDT 2007


try to use another codec on the pots dial-peer, g711ulaw or g711alaw.

cheers

Brian Henry schrieb:
> I have a CCM 4.3(1) with 2821 VGW 12.4(11)T1 running in H323 mode.
>  
> Testing:
>  
> Using LAN Line
> I can call into VGW and receive ring tone on call setup/proceed.
>  
> Using 7961 8.2(2)sr1
> I can call out but certain numbers I call do not connect and get, and 
> also do not get ring indicator
> call_progress: DEV_CONNECTED VOICE ERROR: Bearer capability not 
> available(0x3A): b channel 2 call id 0x50D
>  
> IP Communicator 2.1(1)
> Can call anywhere and receive ring indicator as well as get connected to 
> calls that I cannot through regular hard phones.
>  
> I have added the progress_ind setup/connect/progress commands under the 
> pots dial-peers to correct the ring back issue but to no avail.
>  
> I do not have Display IE checked and I am not running fast-start for 
> inbound nor outbound.
>  
> DSP's are in flex mode and the firmware is 9.2.2 I do believe.
>  
>  
> Very weird stuff when I can call everywhere with IPC but not a hard 
> phone and the funny thing is that sometimes I can call it.
>  
> Brian
> 
> 
> ------------------------------------------------------------------------
> 
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip



More information about the cisco-voip mailing list