[cisco-voip] CM 4.1(3)SR5

[Matt Slaga (US)]

I've seen this almost exact problem  once before.  It was caused by the
carrier forgetting to assigning a PSAP location to the circuit.

 

 

 

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Brian Henry
Sent: Thursday, May 24, 2007 2:51 PM
To: Derek Hover; ciscovoip
Subject: Re: [cisco-voip] CM 4.1(3)SR5

 

What is configured on your route pattern for "911"?

Are you using CER? (Cisco Emergency Responder)?

What number should be passed to the PSAP when dialing 911 if you are not
using CER? most likely the main number to the business.

Does your Route Pattern or Route List Restrict CLID?

If not

Then make sure you check you calling Parties Mask, but change the CLID
to the 10-Digit Main Number, make sure that you allow on your
RouteList(on the Route Groups for the RouteList).

 

Brian

 

________________________________

From: cisco-voip-bounces at puck.nether.net on behalf of Derek Hover
Sent: Thu 5/24/2007 2:30 PM
To: ciscovoip
Subject: Re: [cisco-voip] CM 4.1(3)SR5

 

Now that it's out, anyone taking a stick to it yet?

Derek

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jonathan
Charles
Sent: Thursday, May 24, 2007 2:13 PM
To: ciscovoip
Subject: [cisco-voip] Unallocated/Unassigned Number for 911 call...

So, made a 911 test call:

VOICEGW#
*May 24 18:13:39.451: ISDN Se0/0/0:23 Q931: TX -> SETUP pd = 8
callref = 0x004D
        Bearer Capability i = 0x8090A2
                Standard = CCITT
                Transfer Capability = Speech
                Transfer Mode = Circuit
                Transfer Rate = 64 kbit/s
        Channel ID i = 0xA98394
                Exclusive, Channel 20
        Calling Party Number i = 0x0181, '[removed]'
                Plan:ISDN, Type:Unknown
        Called Party Number i = 0x80, '911'
                Plan:Unknown, Type:Unknown
*May 24 18:13:39.527: ISDN Se0/0/0:23 Q931: RX <- RELEASE_COMP pd = 8
callref = 0x804D
        Cause i = 0x8081 - Unallocated/unassigned number


Any ideas?



Jonathan
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip




-----------------------------------------
Disclaimer:

This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the
designated addressee(s) named above only.  If you are not the
intended addressee, you are hereby notified that you have received
this communication in error and that any use or reproduction of
this email or its contents is strictly prohibited and may be
unlawful.  If you have received this communication in error, please
notify us immediately by replying to this message and deleting it
from your computer. Thank you.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070524/eac61a47/attachment.html