[cisco-voip] Problem with 7920 - ringing but no sound

Konne bridge_stone at gmx.net
Fri May 25 09:13:02 EDT 2007


hi,

now i've found the problem i have configured the wlancontroller to do 
"Peer to Peer Blocking Mode". now all is ok.

thx

Erik Goppel wrote:

> Konne,
>  
> Is that you have ringing on the phone, but you don`t hear the 
> ringtone? or is it no audio in your call?
> Can you hear the ringtone, if you change it on the phone?
> It could be, that the ringtones are not served on you CME, you will 
> have to include them in your tftp-server configuration, which is 
> missing by the way in your configuration.
> If you are running cme, and the raw files are not uploaded to the 
> phone, but the are accesible in your (default) ringlist, it cannot 
> play the audio, excepte for the default raw files that come preloaded 
> in the phone.
>  
> So i would advise you to read the CME installation and configuration 
> document, on how to configure this correctly.
>  
> good luck,
>  
> erik
>
>  
> 2007/5/25, Konne <bridge_stone at gmx.net <mailto:bridge_stone at gmx.net>>:
>
>     Konne wrote:
>
>     > hi,
>     >
>     > no audio at all, only a noise...
>     >
>     > bye
>     >
>     > Matthew Saskin wrote:
>     >
>     >> Are you getting no audio at all or only one way audio?
>     >>
>     >> -matt
>     >>
>     >> Konne wrote:
>     >>
>     >>> hi @ all,
>     >>>
>     >>> i have a little problem with my Cisco VoIP. I' ve a WLAN
>     >>> Infrastructure and i would like to implement VoIP now.
>     >>> my problem is that the phones are communicating well, only that i
>     >>> can hear nothing.
>     >>>
>     >>> have you any suggests
>     >>>
>     >>> thx
>     >>>
>     >>>
>     >>> my network:
>     >>>
>     >>>
>     >>> Router2811 with DSP ----- TRUNK dot1q ------
>     >>> Catalyst3750------------ ACS
>     >>>
>     >>>                   |
>     >>>
>     >>>                   |
>     >>>
>     >>>             AP1240
>     >>>
>     >>>
>     >>>                                                           ephone1
>     >>> 7920                     ephone2 7920
>     >>>
>     >>>
>     >>> my config Router2811:
>     >>>
>     >>> router2811#sh run
>     >>> Building configuration...
>     >>>
>     >>> Current configuration : 2961 bytes
>     >>> !
>     >>> ! Last configuration change at 11:52:04 MESZ Thu May 24 2007 by
>     >>> router2811
>     >>> ! NVRAM config last updated at 11:52:06 MESZ Thu May 24 2007 by
>     >>> router2811
>     >>> !
>     >>> version 12.3
>     >>> service timestamps debug datetime msec
>     >>> service timestamps log datetime msec
>     >>> service password-encryption
>     >>> !
>     >>> hostname router2811
>     >>> !
>     >>> boot-start-marker
>     >>> boot-end-marker
>     >>> !
>     >>> logging buffered 51200 warnings
>     >>> !
>     >>> clock timezone MEZ 1
>     >>> clock summer-time MESZ recurring last Sun Mar 2:00 last Sun
>     Oct 3:00
>     >>> no aaa new-model
>     >>> ip subnet-zero
>     >>> !
>     >>> !
>     >>> ip cef
>     >>> !
>     >>> !
>     >>> ip domain name +++++
>     >>> ip name-server 192.168.138.10 <http://192.168.138.10>
>     >>> ip name-server 192.168.138.11 <http://192.168.138.11>
>     >>> no ftp-server write-enable
>     >>> !
>     >>> voice-card 0
>     >>>  no dspfarm
>     >>>  dsp services dspfarm
>     >>> !
>     >>> username +++++++ privilege 15 secret 5 ++++++++
>     >>> !
>     >>> !
>     >>> !
>     >>> !
>     >>> interface FastEthernet0/0
>     >>>  no ip address
>     >>>  duplex auto
>     >>>  speed auto
>     >>> !
>     >>> interface FastEthernet0/0.1
>     >>>  description Management
>     >>>  encapsulation dot1Q 1 native
>     >>>  ip address 192.168.250.20 <http://192.168.250.20>
>     255.255.255.0 <http://255.255.255.0>
>     >>> !
>     >>> interface FastEthernet0/0.138
>     >>>  description Server
>     >>>  encapsulation dot1Q 138
>     >>>  ip address 192.168.138.2 <http://192.168.138.2> 255.255.255.0
>     <http://255.255.255.0>
>     >>>  no cdp enable
>     >>> !
>     >>> interface FastEthernet0/0.184
>     >>>  description Admin
>     >>>  encapsulation dot1Q 184
>     >>>  ip address 192.168.184.2 <http://192.168.184.2> 255.255.255.0
>     <http://255.255.255.0>
>     >>>  no cdp enable
>     >>> !
>     >>> interface FastEthernet0/0.880
>     >>>  description VoIP
>     >>>  encapsulation dot1Q 880
>     >>>  ip address 10.95.180.5 <http://10.95.180.5> 255.255.255.0
>     <http://255.255.255.0>
>     >>> !
>     >>> interface FastEthernet0/1
>     >>>  no ip address
>     >>>  shutdown
>     >>>  duplex auto
>     >>>  speed auto
>     >>> !
>     >>> ip classless
>     >>> !
>     >>> !
>     >>> no ip http server
>     >>> ip http authentication local
>     >>> ip http secure-server
>     >>> ip http timeout-policy idle 60 life 86400 requests 10000
>     >>> !
>     >>> access-list 10 permit 192.168.184.0 <http://192.168.184.0>
>     0.0.0.255 <http://0.0.0.255>
>     >>> access-list 10 permit 192.168.185.0 <http://192.168.185.0>
>     0.0.0.7 <http://0.0.0.7>
>     >>> access-list 10 permit 192.168.250.0 <http://192.168.250.0>
>     0.0.0.255 <http://0.0.0.255>
>     >>> !
>     >>> !
>     >>> !
>     >>> control-plane
>     >>> !
>     >>> telephony-service
>     >>>  max-ephones 10
>     >>>  max-dn 10
>     >>>  ip source-address 10.95.180.5 <http://10.95.180.5> port 2000
>     >>>  time-format 24
>     >>>  date-format dd-mm-yy
>     >>>  user-locale DE
>     >>>  network-locale IT
>     >>>  create cnf-files version-stamp 7960 May 23 2007 12:24:26
>     >>>  max-conferences 8
>     >>>  transfer-system full-blind
>     >>>  transfer-pattern ...
>     >>> !
>     >>> !
>     >>> ephone-dn  1
>     >>>  number 750
>     >>> !
>     >>> !
>     >>> ephone-dn  2
>     >>>  number 751
>     >>> !
>     >>> !
>     >>> ephone  1
>     >>>  mac-address 0019.AAmac
>     >>>  button  1:1
>     >>> !
>     >>> !
>     >>> !
>     >>> ephone  2
>     >>>  mac-address 0019.AAmac2
>     >>>  button  1:2
>     >>> !
>     >>> !
>     >>> line con 0
>     >>>  login local
>     >>> line aux 0
>     >>> line vty 0 4
>     >>>  access-class 10 in
>     >>>  exec-timeout 30 0
>     >>>  privilege level 15
>     >>>  login local
>     >>>  transport input telnet ssh
>     >>> line vty 5 15
>     >>>  access-class 10 in
>     >>>  exec-timeout 30 0
>     >>>  privilege level 15
>     >>>  login local
>     >>>  transport input telnet ssh
>     >>> !
>     >>> scheduler allocate 20000 1000
>     >>> ntp server 62.101.81.203 <http://62.101.81.203> source
>     FastEthernet0/0.138
>     >>> ntp server 62.152.126.5 <http://62.152.126.5> source
>     FastEthernet0/0.138
>     >>> !
>     >>> end
>     >>>
>     >>> _______________________________________________
>     >>> cisco-voip mailing list
>     >>> cisco-voip at puck.nether.net <mailto:cisco-voip at puck.nether.net>
>     >>> https://puck.nether.net/mailman/listinfo/cisco-voip
>     >>>
>     >>
>     >>
>     >>
>     >
>     >
>
>     _______________________________________________
>     cisco-voip mailing list
>     cisco-voip at puck.nether.net <mailto:cisco-voip at puck.nether.net>
>     https://puck.nether.net/mailman/listinfo/cisco-voip
>
>



More information about the cisco-voip mailing list