[cisco-voip] Catalyst 6500 switch as Voice Gateway

[Lelio Fulgenzi]

sure, you can use the CMM modules with FXO or PRI ports.

take a serious look at comparing the cost of the blades with an ISR though.

you'll be surprised as to how much cheaper it can be.

and you'll get to use the ISR for all sorts of other stuff like SRST. granted you can use the CMM for SRST but it is limited in memory.


--------------------------------------------------------------------------------
Lelio Fulgenzi, B.A.
Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1
(519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ 
"Buffalo buffalo Buffalo buffalo buffalo buffalo Buffalo buffalo."      WJR

  ----- Original Message ----- 
  From: zohaib shabir 
  To: cisco-voip at puck.nether.net ; cisco-voip-request at puck.nether.net 
  Sent: Friday, May 25, 2007 1:04 PM
  Subject: [cisco-voip] Catalyst 6500 switch as Voice Gateway


  Dear All,
  Can we use Catalyst 6500 series switch as Voice gateway.

  -- 
  Regards,
  Zohaib Shabir
  Network Engineer(Voice and PreSales)
  DWP Group, TECH Division
  Ph:+92-302-8232689 


------------------------------------------------------------------------------


  _______________________________________________
  cisco-voip mailing list
  cisco-voip at puck.nether.net
  https://puck.nether.net/mailman/listinfo/cisco-voip
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20070525/160bd488/attachment.html