[cisco-voip] Avaya integration with Cisco Router 3845

[Aman Chugh]

It will not work as you are using E1 G.703 card. You would need
VWIC/2MFT1/E1 card for this integration, also check out the cisco
interoperability portal for integrating different PBX with cisco routers .

Aman


On 11/9/07, zohaib shabir <zohaibshabir at gmail.com> wrote:
>
> Hi All,
> I am having a physical layer problem in integrating the Avaya G3 Si V8
> with Cisco Router 2811. The problem when i connect the PBX through the E1
> connection with the router the E1  interface is down without any alarm, what
> i can see is Line Code Voilations and Path Code Violations on the router and
> from the PBX side the interface is sync but is not in IDLE mode or you can
> say it will not accept any calls. I have hard loped both PBX and router in
> the middle from which they are connecting hardloping makes the E1 interface
> UP and also make  PBX able to attend calls, but when i join them problem
> arises.The router has two port E1 G.703 card. Is there any one who can
> help me out in this regard.
>
> --
> Regards,
> Zohaib Shabir
> Network Engineer(Voice)
> DWP Group, TECH Division Karachi
> Ph:+92-302-8232689
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20071109/2c72fbd2/attachment-0001.html