[cisco-voip] POTS rather than Pri

[Lelio Fulgenzi]

Take a look at Adtran...it's a device that can take in analog ports and output to PRI...or so I've been told.

But remember, from fast, good and cheap, you can pick two....but not all three. ;)

The Atlas product line is what might help you out.




----- Original Message ----- 
From: "Curt Shaffer" <cshaffer at gmail.com>
To: <cisco-voip at puck.nether.net>
Sent: Tuesday, November 13, 2007 5:28 PM
Subject: [cisco-voip] POTS rather than Pri


>I have a project to install a CME system for a customer. This was turned
> over to me from another, unrelated, installer. It appears that the router
> (2811) was ordered with a PRI interface and 4 FXO ports. The problem is that
> the customer is actually running on 14 POTS lines. To make matters worse,
> their current old phone system is dying more and more every day. 
> 
> I'm basically trying to see how I can salvage time and get them migrated on
> schedule. A change to PRI is going to take a while so while that is probably
> the best option, I am stuck with the current system failing. Does anyone
> have any recommendations of a device (ATA or similar) that I can use to take
> in 14 POTS lines and bring it into the CME box? Time, low cost and
> reliability are obvious requirements here. I will probably start the ball
> rolling on the PRI order but I am sure that is not going to be ready for at
> least 60 days.
> 
> 
> Thanks for the input
> 
> Curt
> 
> 
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20071114/163ae5d6/attachment.html