[cisco-voip] Mobility Voice Access not working

[Justin Steinberg]

I setup MVA using h323 hairpinning and had no problems with it, in
fact, i was suprised at how easy it was.

below is my ios config.  on the cm side, i setup a h323 gw and a route pattern.


voice service voip
 allow-connections h323 to h323

application
 service CMM http://172.31.24.25:8080/ccmivr/pages/IVRMainpage.vxml

dial-peer voice 84625555 voip
 service cmm
 destination-pattern 84625555
 session target ipv4:172.31.24.25
 incoming called-number 84625555
 dtmf-relay h245-alphanumeric
 codec g711ulaw
 no vad
!



On Nov 14, 2007 9:40 PM, Jason Wydra <jasonwydra at gmail.com> wrote:
> CUCMBE 6.0(1)
> 2811 12.4(13r)T
>
> I can't seem to get mobile voice access working. I followed the directions
> to a T but I still can't get the IVR portion to answer. I configured the
> H323 gateway as shown below. I also added the dial-peers as shown in the
> config guide. I still get a fast busy when I call the external access DID
> from a cell phone. Q931 shows the call coming into the gateway but it gives
> me an unallocated/unassigned number error. Is there a trick to get this vxml
> application to trigger? Do I have to load something into flash in order for
> it to work? All configs on the CallManager side are complete. Thanks!
>
> Step 3
>
>
> Load the VXML application from the Cisco Unified Communications Manager
> server (Publisher).
>
> Sample configuration for IOS Version 12.3 (13) and later:
>
> •application service CCM
>
> •http://<Unified CM cluster Publisher IP
> Addr>:8080/ccmivr/pages/IVRMainpage.vxml
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>