[cisco-voip] Installing BARS after everything

[Jonathan Charles]

You CAN'T install BARS beforehand.

I just tried it on a box that was going to be a CRS 4.5 box... and it
said, 'telephony application not found'...



Jonathan

On Nov 20, 2007 1:07 PM, Scott Voll <svoll.voip at gmail.com> wrote:
> I think the docs are smokin crack.... you can't install bars on CRS
> until you have the application installed from what I can remember.
> I've always installed after.
>
> Scott
>
>
> On Nov 13, 2007 8:50 AM, Cucumber Green <greencucumber2007 at yahoo.com> wrote:
> > I have a couple of CRS servers and Call Managers in several clusters that do
> > not have BARS installed. So I can not really properly back them up. I was
> > reading this doc prior to even try installing BARS on them , but then I came
> > across this note:
> >
> > "Cisco strongly recommends that you install BARS before you install the
> > supported Cisco IP telephony application."
> >
> > Does this means I am screwed? Have anyone installed BARS after having a
> > working CRS or CM?
> >
> > (
> > Cisco doc is
> > http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_installation_guide_chapter09186a00801ebeac.html
> > )
> >
> >
> > ________________________________
> > Never miss a thing. Make Yahoo your homepage.
> >
> >
> > _______________________________________________
> > cisco-voip mailing list
> > cisco-voip at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/cisco-voip
> >
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>